Caller ID Output Examples

The first two Identifier output examples are annotated examples of the real time data from the Identifier with all events enabled. The example is two calls, Line 2 calling Line 1, with Caller ID and the second example with Distinctive Ring and no Caller ID.

This example has all real-time events enabled. Each type of event may be selectively turned on or off with the ATF command (see manual).

All data is output in a fixed field format.

(Technical Content for Programmers)


+2,4,002				     OFF HOOK OUTGOING LINE 2
+5,3,002				     DTMF DIGIT 3 PRESSED LINE 2
+5,4,002					  "      4        "
+5,4,002					  "      4        "
+5,7,002					  "      7        "
+5,6,002					  "      6        "
+5,6,002					  "      6        "
+5,5,002					  "      5        "
+2,1,001				      RING START LINE 1
+2,2,001				      RING STOP LINE 1
+1,9543440584,Y E S SOFTWARE ,001	      CALLER ID INFO INCOMING LINE 1
+2,1,001				      RING START LINE 1
+2,2,001				      RING STOP LINE 1
+2,3,001				      OFF HOOK INCOMING LINE 1
+2,0,002				      ON HOOK LINE 2 IDLE
+2,0,003				      ON HOOK LINE 1 IDLE


+2,4,002			     OFF HOOK OUTGOING LINE 2
+5,3,002			     DTMF DIGIT 3 PRESSED LINE 2
+5,4,002				  "      4        "
+5,4,002				  "      4        "
+5,7,002				  "      7        "
+5,6,002				  "      6        "
+5,6,002				  "      6        "
+5,5,002				  "      5        "
+2,1,003			      RING START LINE 3
+2,5,003			      RING STOP LINE 3 WITH 2 BURST DISTINCTIVE RING
+2,1,003			      RING START LINE 3
+8,2,003			      CALLER ID SIGNAL ERROR 2 ( NO SIGNAL )
+2,5,003			      RING STOP LINE 3 WITH 2 BURST DISTINCTIVE RING
+2,0,002			      ON HOOK LINE 2 IDLE
+2,0,003			      ON HOOK LINE 3 IDLE

The following is an example of the same two call as above with the Identifier in SMDR printer output mode. One line of data is output upon termination of the call.

O 2  01/01 11:59   1.3	   344 7665
I 1  01/01 12:00   1.2 954 344 0584 YES SOFTWARE
O 2  01/01 11:59   1.3	   344 7665
I 3- 01/01 12:02   1.2				The minus indicates 2 burst distinctive ring

The following is an annotated example of querying the Identifier for details on an in process call. This is done through issuing the ATS (Status) command. If the line is in use, a +6 call detail is returned with the +7 current status. The format of the call status is:

Date & Time formatted as MMDDhhmmss,
Phone Number (incoming and outgoing),
Number of Rings or 'O' for outgoing calls,
Seconds off hook,
Line Number

ATS1							Command sent, Status Line 1
+6,010111200,9543440584,Y E S SOFTWARE ,2,00066,001	Call detail response and
+7,3,001						Call Status, off hook incoming

ATS2						 Command sent to the Identifier
+7,0,002					 Call Status, on hook idle
						 No call detail is available